|
Who's Online
There currently are 5965 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
Found website easy to use and manual very clear. First class service
;
The quality is quite good and clear. Nothing of the informations inside is lost during the digitalizing process
;
Very good service, fast downloads and good manuals.
;
Good qulity. Even as it is an old manual (from 1991-1992) it has a good scanned quality and is complete, including user's manual, disassembly intructions, diagrams and schematics, ajustments, troubleshooting and parts list, as usual with SONY manuals and Owner-manuals service.
;
tres bon document
cela a permis de verifier la connection de l'ecran
merci
salutations
ITEM HEIGHT (HIT) 1. 2. 3. 4.
ADJUSTMENT PROCEDURE Receive NTSC signal. Select the "FULL" mode by PIC SIZE button on Remote Control. Call up the adjustment mode display and select the item HIT. Press the VOLUME s or t button to get the picture so that top and bottom of video signal begin to lack. 5. Press the VOLUME s button to advance the data by 8 steps. Note: Check the vertical picture position is correct. Adjust the data of height after vertical linearty. 1. Receive cross-hatch pattern. 2. Call up the adjustment mode display, then select the item VLIN. 3. Press the VOLUME s or t button to obtain the picture of the best linearity. 4. Then readjust the item HIT.
VERTICAL LINEARITY (VLIN) (FULL mode only)
WHITE BALANCE (RCUT) (GCUT) (BCUT) (RDRV) (BDRV)
1. Press RESET button on TV or remote hand set. 2. Call up the adjustment mode display, then adjust the data of items RCUT, GCUT and BCUT to �80�. 3. Press TV (ANT)/VIDEO button on TV. 4. Gradually rotate R, G and B SCREEN volume of FOCUS PAC (page 9) clockwise or counterclockwise until the raster appears slightly on the CRT through the each lens, and leave them. (Look into the lens in order to check the raster.) 5. Press TV (ANT)/VIDEO button on TV again. 6. Exit from service mode. 7. Receive white laster pattern signal, and adjust the contrast to the minimum to make white picture to low light. 8. Adjust the data of items RCUT, GCUT and BCUT for low light area. 9. Adjust the contrast to the maximum to make white picture to high light. 10. Adjust the data of items RDRV and BDRV Controls for proper white-balanced picture in high light area. 11. Check the white balance in both low and high light areas. If necessary, perform again steps from 7 to 9.
� 13 �
SPECIFIC INFORMATIONS GENERAL ADJUSTMENTS
|
|
|
> |
|