|
Who's Online
There currently are 5978 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
Great manual very clear copied. You are making an incredible job. I appreciate a lot the rapidity and your efficiency. Thanks a lot
;
Good pdf of the service manual for this unit. Includes disassembly instructions, full schematics, board layouts, parts lists and diagnostic information. Some information is in the pdf twice (single pages, and split pages), but that could be how it was originally generated by panasonic, or perhaps the idea is to make it eaiser to put onto 8.5 x 11" pages.
Information was exactly what I needed. Delivery was overnight (less than 12 hours) and I was happy with the process.
;
5 STARS for FAST DELIVERY, BEST PRICES and QUALITY PRODUCT. Item was exactly as described with superb resolution. Will definitely source all my future requirements from this website. Thanks a lot owner-manual.com!
;
OEM manual provided all schematics, board layouts and component specs necessary to facilitate unit maintenance. All pages were clear and readable.
;
Good condition and quality. Hard to find anywhere in Internet, only on this site.
3. The base and handset cannot be connected.
Check whether the base is able to set in the test mode 1.
NG
Check IC22 and its peripheral circuit.
OK
Check the TX POWER and NG the TX FREQUENCY on the base unit. Check base RF unit.
OK
Set the base in the test mode 3, check whether deviation of the TX data is app. 8 kHz Dev.
NG
Check whether there is a NG 250Hz data waveform at C232.
Check RT3, C234, R58 and C232.
OK
Check base RF unit.
OK
Set the base in the test mode 8, 902.952467 MHz (250 Hz ±8 kHz Dev.) 1mV output signal from RF jack is applied. Does the bell ring?
NG
Check whether there is a NG 250 Hz data waveform at pin 9 of IC1.
Check base RF unit.
OK
Check whether there is a 250 Hz data waveform at the Q6 collector.
NG
Check RT2, Q6 and their peripheral circuit.
OK
OK
Check whether there is a NG 250Hz data waveform at pin 39 of IC22. Check IC18 and its peripheral circuit.
OK
Check IC22 and its peripheral circuit.
Check whether the handset NG is able to set in the test mode 1.
Check
IC603
and
its
peripheral circuit.
OK
Check the TX POWER and NG the TX FREQUENCY on the handset unit. Check handset RF unit.
OK A
18
|
|
|
> |
|