|
Who's Online
There currently are 5082 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
The TEAC A-1500's Service Manual was instrumental in reviving this classic reel-to-reel. Not only does it have the schematics, exploded parts diagram and parts list, it also provided mechanical adjustment information that approximate factory default settings.
;
This service manual was determinant to enable to fix my Alpine Amplifier. I am pleased with my purchase. For a 5 star rating I would like to see a higher resolution scan of the printed circuit board lay-out because the gray scale grafics was dificult to see. Also some schematic diagrams were scanned at a slight angle. Never the less, it had all information I needed to troubleshoot and service my equipment.
;
Complete manual, the good quality of reproduction allows enlarged print-out of the schematic diagram in the size it probably had in the original print edition and which is necessary for practical use.
;
The service manual was complete and the components on the drawings very good visible.
;
downloaded next day , manual is very helpful , fast and easy
Tray (3)
� Confirm that the mark of the gear matches with the triangle mark on the reverse side of the tray in the tray close status. (The gear is rotated with the slider locks.) (Refer to Fig. B.)
Fig. A Gear (4) Triangle mark
B
Tray panel (4)
A
Tray (3)
Claws
Tray panel (4)
Position of the line Pickup mechanism assembly Gear (4) The first tooth of the gear of this side on the tray rack gear.
Fig. 2-1-5 1-1-4. Front Panel and Tray 1. Remove the flexible cable (1). 2. Remove one screw (2) and remove the GND lead (3). 3. Release four claws and remove the front panel (4). 4. Pull out the tray (5) to this side.
Screw (2) GND lead (3) Claw
Fig. B Marking Gear Tray (3) Triangle mark
Slider
Fig. 2-1-7 1-1-5. Rear Panel 1. Remove three screws (1) and remove the rear panel (2).
Rear panel (2)
Tray (5) Claws Front panel (4)
Flexible cable (1) Claw
Screws (1)
Fig. 2-1-6 Note: � Insert the tray (3) with the front side of the pickup mechanism assembly descended. (The slider positions to the left side.) � The gears are required to match their phases each other. After setting the gear (4) as shown in the figure �A�, insert the tray (3). When inserting a tray (3), push the rack gear side shown by the arrow. Fig. 2-1-8
|
|
|
> |
|