|
|
|
Who's Online
There currently are 5985 guests and
2 members online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Excellent just what I needed to replace the electrolytic caps and make this old gem a beauty again. Was as scan of the original photocopied service manual.
;
It was helpful to get schematic with waveforms in important points and lot of service information. Manual is good quality, fast delivered. Of course it is hardcopy of paper one with all its disadvantages.
 ;
I want to give you a real heads-up for your desire to enable such people as I to acquire the information I need to maintain the older types of equipment such as this Akai HXA351W. You do a swell job with all the processes you have to perform so I can have a legible, thus usable
document which does not send me crazy trying to figure out the blurry text of a bad copy.
Very well done, Thomas.
;
This manual is very well presented and after printing out looks about as close to an original as I think you can get. The quality is second to none.
The content of the manual is comprehensive and I think it would be well suited to an audio repair professional which I'm not but I did find it very informative and helpful.
The cost of the manual is more than covered by the money I'll save when I change the keep memory battery now I have the relavant info.
Very pleased with my purchase and can recommend it wholeheartedly as I can other manuals I've downloaded from this site.
Regards
Limey Alex
;
Complete manual including mechanical part in good pdf quality. Shaded greys of the pcb due to pdf not perfect but usable.
2. Caution in Replacing Parts
Check whether or not the DVD drive, 42-pin FFC and the main board are connected properly after replacing the DVD drive or the main board. Then, remove the pick protective solder (two points.) Before replacing the DVD drive or the main board, be sure to solder on the DVD drive to prevent damage by static electricity.
Pick protective solder
Solder the harness connecting from the DVD drive on the edge of the main board as the figure shown below after replacing the DVD drive or the main board. If not, reassembling can not be performed properly due to interference between parts.
Land for soldering
The harness connecting from the DVD drive
When replacing PJ705, cut the connector end on the back of the board within 1mm after soldering. If not, reassembling can not be performed properly due to interference between parts.
Cut the connector end. Within 1mm
When replacing the label, be sure to fill in the serial number and stick the seal on the label for protection.
|
|
|
> |
|
