This document is just what I was looking for, it´s very useful, it contains adjustment procedures for the final stage of the power amp and also
has a complete wiring diagram and description of the main semiconductors used in the design.
Dear Sirs,
Thank you for the fast support, the manual does provide all necessary information to repair the radio. All schematics are in a good quality for reading.
The manual fits 100% to my requirements as a technican.
Kind regards Thomas
Text excerpt from page 13 (click to view)
3. The base and handset cannot be connected.
Check whether the base is able to set in the test mode. OK Check the TX POWER and the TX FREQUENCY on the base unit. OK Press SKIP key twice, check whether the TXD is output from Pin 48 of IC3. OK Check whether the TXD is output from MOD POINT (See page 28). OK Check whether the handset is able to set in the test mode. OK Check the TX POWER and the TX FREQUENCY on the handset unit. OK Press "3" key, check whether TXD is output from Pin 40 of IC601. OK Check whether the TXD is output from MOD POINT (See page 30). OK Place the handset on the base to charge about 5 seconds, then try connecting again. NG Check R620 and the handset RF unit. NG Check IC601 and its peripheral circuit. NG Check the handset RF unit. NG Check IC604 and its peripheral circuit. NG Check R7, R21 and the base RF unit. NG Check IC3 and its peripheral circuit. NG Check the base RF unit. NG Check IC5 and its peripheral circuit.