|
Who's Online
There currently are 5947 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
Readable text and good copy. Very much needed if you wish to do some repairs on this fine old unit.
;
Fint forløb med levering af manualen. Kvaliteten af skanningen betegnes som middel
;
I found the manual to be clear concise and complete. It was of immense assistance when removing the unit as the unit was over 22 years old and the wiring diagram was unobtainable from the manufacturer. The exploded drawings were clear as were the instructions and labels.
;
I will highly recommend this seller. They are honest, accurate, fast and responsible.
;
This manual was very good & was very helpful with repairs.
Always great & fast service from Owner's manual.
Chapter 7
Projector Setup
Plug in the power cord; turn on main power switch and the power of the projector.
How to enter to the Factory Mode (TLP-X2500/XC2500/X3000/XC3000)
1) While the Volume adjustment bar is displayed on the screen, set value to [2], and press the buttons, [Input], [On/Standby] and [Keystone] simultaneously. 2) While the Volume adjustment bar is displayed on the screen, set value to [0], and press the buttons, [Input], [On/Standby] and [Keystone] simultaneously. 3) While the Volume adjustment bar is displayed on the screen, set value to [0], and press the buttons, [Input], [On/Standby] and [Keystone] simultaneously. 4) While the Volume adjustment bar is displayed on the screen, set value to [0], and press the buttons, [Input], [On/Standby] and [Keystone] simultaneously.
When the projector enters to the Service Mode, the buzzer beeps for 3 seconds. If doesn�t beep, repeat from the beginning. This mode maintains until you turn off the main power switch.
7-3
|
|
|
> |
|