Wonderful service... doubt that I could have made the repairs to my turntable without this service manual. Great help!
Well worth the price paid!
Text excerpt from page 47 (click to view)
Disassembly and Reassembly
4-3-27 Motor Capstan Assây Removal
1) Remove the 3 Screws Å. 2) Remove the Motor Capstan Assây Â´. Assembly : 1) Match the 3 holes of Motor Capstan Assây Â´ to the 3 holes of Main Base as attending not to drop or knock the Motor Capstan Assây. 2) Tighten the 3 Screws in the direction of arrow as shown detail drawing. Note : 1) Donât reuse the removed screws from Motor Capstan Assây. 2) After tightening screws, check if there is gap between the head of screws and the top side of Main Base. There should have no gap between the head of screws and the top side of Main Base. 3) After reinstalling, adjusting the tape transport system again.
4-3-28 How to Eject the Cassette Tape (If the unit does not oprate on condition that is inserted into housing assây)
1) Remove the Holder worm Å and the Gear Worm Â´. 2) Turn the Gear Worm Wheel Ë counterclockwise with screw driver. (Refer to arrow)
Ë GEAR WORM WHEEL
Â´ GEAR WORM Å HOLDER WORM
Å 3 SCREWS
3) When Slider S, T are approched in the position of unloading, rotate holder Clutch counterclockwise after inserting screw driver in the hole of frameâs bottom in order to wind the unwinded tape. (Refer to Fig. 4-36) (If you rotate Gear Worm Wheel continuously when tape is in state of unwinding, you may cause a tape contamination by grease and tape damage. Be sure to wind the unwinded tape in the state of set horizently.) 4) Rotate Gear Worm Wheel Ë counterclockwise using screw driver again up to the state of eject mode and then pick out the tape. (Refer to Fig. 4-35)